Нет, это специальный управляющий код ssh
, в котором перечислены переадресованные соединения. Вы, очевидно, подключены к своей оболочке через SSH-соединение.
bash
сам ответит «команда не найдена», если вы наберете ~#
в командной строке:
$ ~#
bash: ~#: command not found
Обратите внимание, что для ввода~
в оболочке в качестве первого символа после нажатия введите , вам придется дважды нажать ~, если ваша оболочка находится на другой стороне оболочки. Соединение SSH только из-за этих управляющих кодов.
Другие доступные команды перечислены в руководстве ssh
(их необходимо вводить первыми символами после нажатия Enter):
~. Disconnect.
~^Z Background ssh.
~# List forwarded connections.
~& Background ssh at logout when waiting for forwarded connection /
X11 sessions to terminate.
~? Display a list of escape characters.
~B Send a BREAK to the remote system (only useful if the peer
supports it).
~C Open command line. Currently this allows the addition of port
forwardings using the -L, -R and -D options (see above). It also
allows the cancellation of existing port-forwardings with
-KL[bind_address:]port for local, -KR[bind_address:]port for
remote and -KD[bind_address:]port for dynamic port-forwardings.
!command allows the user to execute a local command if the
PermitLocalCommand option is enabled in ssh_config(5). Basic
help is available, using the -h option.
~R Request rekeying of the connection (only useful if the peer
supports it).
~V Decrease the verbosity (LogLevel) when errors are being written
to stderr.
~v Increase the verbosity (LogLevel) when errors are being written
to stderr.
Установите следующие пакеты:
sudo dnf install man-pages man-db man
mandb