Ответ нашелся при детальном просмотре документации:
https://www.centos.org/docs/5/html/Cluster_Logical_Volume_Manager/physvol_create.html
dd if=/dev/zero of=/dev/sdb bs=512 count=1
Из документации, указанной выше:
4.2.1.1. Setting the Partition Type
If you are using a whole disk device for your physical volume, the disk must have no partition table. For DOS disk partitions, the partition id should be set to 0x8e using the fdisk or cfdisk command or an equivalent. For whole disk devices only the partition table must be erased, which will effectively destroy all data on that disk. You can remove an existing partition table by zeroing the first sector with the following command:
После выполнения этой команды мне удалось создать физический том.
в моем случае это было то, что module-switch-on-connect
не был загружен, добавление load-module module-switch-on-connect
к /etc/pulse/default.pa
должно решить проблему, если только. вы можете проверить загруженные в данный момент модули с помощью pactl list modules
. если добавление его в файл conf не работает, вы можете добавить pactl load-module module-switch-on-connect
к вашему ~/.xsessionrc
.
https://forum.xfce.org/viewtopic.php?pid=58124#p58124https://forum.xfce.org/viewtopic.php?id=13040